Audio, Maintence, Maintence Reminders, and Standby
The Audio section in the settings menu of in.stream gives you the option to disconnect or un-pair your Bluetooth enabled device when using the in.stream. The in.stream 2 settings menu gives you a source selector, a Bluetooth disconnect option, an On/Off switch and an audio control on fader, balance and subwoofer.
From the settings page you can access the Maintenance menu, which gives you the following options:
- Maintenance Reminders
Use the Up and Down buttons to make a selection, and the Light button to confirm.
The In.k500 keypad will remind you of maintenance required on your spa, like rinsing or cleaning the filter. Each task has its own duration, based on normal use. The maintenance reminders menu allows you to verify the time left before maintenance is required, as well as to reset the time once a task is completed. Use the Up and Down button to move through the list. To reset a task select it by pressing the Light button, then confirm when prompted. Once you have confirmed the task will be reset.
The standby mode allows you to service your spa. Pumps will stop for 30 minutes, and automatically restart after this time. Once Standby Mode has been activated a screen will appear to show that pumps are stopped. The normal spa page will return at the end of Maintenance.
Press Button 1 to leave standby mode and restart the spa.